|
- Pin compatible with the Dini Group DN3000k10/S prototyping
board
- Intel LXT1000 single-chip PHY for ethernet
- IEEE 802.3ab compliant Ethernet, (1000BASE-T, 100BASE-TX, 10BASE-T)
- IEEE 802.3ab auto-negotiation with support for master/slave
control and flow control
- No configuration required. Add Gigabit Ethernet capabilities
to your DN3000K10/S design
- Programmable CPLD, 144 macro cells (3200 usable gates), JTAG
support
- RJ-45 Ethernet connector
- Status LEDs
- Low power 3.3V operation
- CPLD and DN3000k10/S Verilog code
- Full and Half-Duplex operation for 10/100/1000 with automatic
fallback support
- Product Brief [PDF - 387KB]
- FAQ [PDF - 55KB]
- Intel LXT1000 Datasheet [PDF]
- Daughter Card Compatibility Guide [PDF - 65KB]
- 200-pin Header Connection Summary [XLS - 2.7MB]
Contact Info:
MetaNetworks Technologies Inc.
1440 McCarthy Blvd.
Milpitas, CA 95035
Phone (408) 965-5198 |
MP1000TX Gigabit Ethernet Prototyping Board
The MP1000TX Gigabit Ethernet Daughter Board adds
Gigabit Ethernet capabilities to the line of FPGA based emulation
products available from the Dini Group (DN3000K10 series). The MP1000TX
features the Intel LXT1000 Gigabit Ethernet transceiver for reliable
full and half-duplex ethernet connectivity at speeds up to 1000Mbps
with fallback support to 10 and 100 Mbps. The on-board Xilinx XC95144XL
configures the LXT1000 at startup and synchronizes the transfer
of data through the 200-pin Berg connector which mates to any of
the DN3000K10(S) products. Any interface and configuration requirements
to the FPGA are easily satisfied with the programmable Xilinx CPLD.
The MP1000TX Daughter Board can be used with any of the supported
FPGA based emulation products to develop and emulate network processing
hardware, including high speed packet-processing at up to gigabit
line rates.
Related Information
This daughter card is compatible with our line of DN3000K10 products:
Click thumbnail for larger view
|
